Difference between revisions of "Quickstartguide talk:Gluebinder"

From Publication Station
Line 5: Line 5:
* Wait until the machine heat is 155 degrees
* Wait until the machine heat is 155 degrees
* Place your contents into the left hand side slot
* Place your contents into the left hand side slot
* Tighten the clamp until it will not tighten any further by pressing the button illustrated below
[[File:Bookbinder-clamp-button.png]]
* Place your cover sheet on the right hand side
* Place your cover sheet on the right hand side
* Line up the center of your cover with the red arrow
* Line up the center of your cover with the red arrow
[[File:Bookbinder-coverandcontents.png]]
[[File:Bookbinder-coverandcontents.png]]
* Tighten the clamp until it will not tighten any further by pressing the button illustrated below
[[File:Bookbinder-clamp-button.png]]


* Press the green button on the front
* Press the green button on the front

Revision as of 12:34, 13 March 2018

To bind a book using the glue book binding machine you will need to have your pages loose (b), and your cover (a) prepared as a spread.

Bookbinder-pages.png

  • Wait until the machine heat is 155 degrees
  • Place your contents into the left hand side slot
  • Place your cover sheet on the right hand side
  • Line up the center of your cover with the red arrow

Bookbinder-coverandcontents.png

  • Tighten the clamp until it will not tighten any further by pressing the button illustrated below

Bookbinder-clamp-button.png

  • Press the green button on the front

Bookbinder-green-button.png

  • Support the contents with your hand while the cover is attached to the content pages
  • Let the binding and cover clamp to fully disengage before you remove your booklet