Editing Stepcraft (section)

==Setting the parameters==
*Now open the "Parameters" menu and go to "Misc." and make the following settings:
: [[File:Stepcraft2.png|600px]]
*The engraving (tool 1 = red line) is to be set with a depth of 1 mm.
*The clamped workpiece material has a thickness of approximately 3 mm in this example. The cut out is thus a service of 3.5mm (2 tool = blue line).
Note: Numbers with decimal places must be entered with a decimal point. The correct depth setting for tool 2 is therefore 3.5.
In this example the pattern is made of plywood or plastic. The in-feed rate / plunge speed is thereby set to 2 mm / sec and the feed rate to 5 mm / s.
*Set the scaling factor for the sample file to 0.2. Thus, the drawing template is reduced to 20% of the original size.
*Set the Start-/End position as the Origin + Tool lift.