Editing Quickstartguide:UVFlatbed (section)

===At the machine itself===
*First measure the thickness of your material with the calipers.
**If your material is flat, but also a little bumpy, lay it on the table and measure its heighest point.
*Adjust the table height by clicking on '''SETUP''', preset '''MANUAL''' and then on '''CHANGE''' next to 'Table Height'
*Don't panic. Here a bit of maths gets involved. To calculate the correct table height, solve the following: '''table height = 102 mm - [the height of your material]'''.
**For example: you have a piece of wood that is approx. 4 mm thick, then that means 102 mm - 4 mm = 98 mm = table height.
*Click on the little pen to edit the height. Fill in the correct height.
*The table adjusts itself to the submitted height.
*Open the lid and place your subject in the lower right corner. This is its starting point of reference.
**To align your material properly you can use the convenient red tool Baschz made.
*Make sure that, if you're using paper or something similarly thin, that the material is taped down as much as possible. Same goes for wobbly pieces of wood.
*Close the lid and move over to the computer