Quickstartguide:Sublimation

File Preparation

To transfer an image to a piece of fabric, you must save your design as:

• JPEG
• PNG
• PDF
• Photoshop File

Materials

Unfortunately, it is not possible to print on any kind of fabric. It is recommended to use a fabric that is made of synthetic fibres (Nylon, Polyester). These allow the heat of the press to seal the print and make it last longer. It is not recommended to use natural fibres such as cotton or linen, since the print won't stick properly to the fabric and will most likely disappear after the first wash.

What about Denim Jeans?

The same approach goes to denim since the percentage of cotton and polyester or elastane can vary.

Printing

• Open your file in any program you can print from.
• Hit <command+P> on the keyboard or >File>Print to go to the print dialogue.

• Make sure to choose the <SAWGRASS SG800> as the printer.

• Choose <A3/mirrored/one page> or <A4/mirrored/one page> as preset.

(this set the printer to the right paper size, the right color profile and it flips the image)

• Hit print.
• Place the transfer paper face down down (the tekst on the back readable to you) in paper tray.

• Wait till the print is done.
• Go to the Heat Transfer Press to transfer your image.